Bikers Choice Chrome Mini LED Turn Signals with 41mm Clamp (Amber)
When bars or forks get cleaned up, stock turn signals are usually the first thing that look out of place. Too big, too plastic, mounted where they don’t belong once the rest of the bike is stripped down. These Bikers Choice mini LEDs are meant to solve that without turning into a wiring headache.They’re compact enough to disappear visually, but still bright enough to be seen in traffic. Common choice on customs, but they don’t look wrong on mostly stock bikes either. The 41mm clamp makes them easy to place on fork tubes, crash bars, or similar round sections where brackets would normally be required.
What you notice once they’re in your hands
The housing is solid metal, not a thin shell. Has some weight to it.
Chrome plating matches most factory Harley finishes closely, especially older bikes.
LED output is focused and sharp. Not washed out, even in daylight.
Amber lens stays legal for front or rear signal use depending on setup.
Clamp-style mounting saves time when you’re not trying to fabricate brackets.
Practical install and build notes
These are universal signals, so placement depends on the bike and layout. The 41mm clamp works well on many Harley fork tubes and common tubing sizes, but measuring before install is still smart. Wiring is straightforward LED-style, though load resistors or an LED-compatible flasher may be required depending on the bike’s electrical system.Housing size is roughly 1.49 inches in diameter and just under 3 inches long. That’s small enough to clean up the look, but not so tiny that they disappear completely from view.They’re often used front and rear, especially on stripped-down builds or when relocating signals after changing bars or suspension components.
FAQs
Are these turn signals DOT approved?Approval can vary by application. They’re commonly used on street bikes, but local regulations should always be checked.Will these work on both front and rear?Yes. Amber LEDs are commonly used front or rear depending on local requirements and bike layout.Do I need a load resistor for these LEDs?On most Harley models, yes. LEDs draw less power, so a resistor or LED flasher is often needed to prevent fast blinking.What does the 41mm clamp fit?It’s designed for tubing around 41mm in diameter, commonly found on fork tubes and similar mounting points.Are these plug-and-play with stock Harley wiring?They typically require basic wiring work. Connectors may need to be adapted depending on year and model.Are they bright enough in daylight?Yes. Output is noticeably stronger than older incandescent mini signals.Can these replace stock turn signals directly?Physically they can, but wiring and mounting location may require minor adjustments.
Account
Categories
Car filter
Search
Compare
Top
Reviews
There are no reviews yet.